abrasive material
英 [əˈbreɪsɪv məˈtɪəriəl]
美 [əˈbreɪsɪv məˈtɪriəl]
磨料
英英释义
noun
双语例句
- Preparation and properties of up/ al_2o_3 composite for particulate abrasive material
UP/Al2O3复合微粒磨料的制备和性能研究 - Abrasive material used for on-site surface pretreatment of pipeline corrosion protection joint
管道防腐补口现场表面预处理用磨料 - The test results show that wear resistance of tested steel under low stress abrasive depends on material hardness. Wear resistance of quenched microstructure is highest.
结果表明：低应力磨粒磨损的耐磨性主要取决于材料的硬度，淬火态组织的耐磨性最好。 - The machine can improve work efficiency and reduce cost by using the three-phase abrasive material ( gas-liquid-solid) to clean rust and painting with non-air high pressure.
该设备采用了气、液、固三相磨料水射流除锈和无空气高压喷涂技术，大大提高了工作效率，降低了成本。 - Silicon carbide ( SiC) powder, as the abrasive material or the stuffing, has the extensive application in vitrified bonded abrasive product, resin bonded polishing wheel and in diamond polishing wheel.
碳化硅（SiC）微粉作为磨料或填料在陶瓷精磨磨具、树脂抛光砂轮以及金刚石抛光砂轮等方面有着广泛的应用。 - With those parameters the authors analyze the effect of wheel hardness, grinding abrasive material and dressing techniques on the wheel topography.
根据这些信息，分析了砂轮不同硬度、粒度、磨料及修整方式的影响。试验表明，本装置可作为研究砂轮表面形貌的基本工具之一。 - Solid Abrasive Material Double-Sides Lapping Pressure Optimizing Control
固着磨料双面研磨压力的优化控制研究 - It is performed through the verification and analysis of the interrelation of typical materials cutting features ( cutting depth, kerf width, striking capacity) and cutting variables ( water pressure, target distance, cutting rate and so on) and the effeCts of abrasive and material.
验证分析了典型材料的切割特征（切割深度、切口宽度、冲蚀量）与切割变量（水压、靶距、切速等）的关系，以及磨料、材质两大因素的影响。 - On the basis of the characteristics of the lubrication film, surface texture, abrasive particle material and work conditions, it sets up the wear rate analysis calculation formula of piston ring and cylinder liner.
本文在考虑了油膜特性、形貌特性、磨粒特性、材料特性及工况条件等因素的基础上，导出了活塞环&缸套的三体磨粒磨损分析计算公式。 - Advantages and disadvantages of various methods were analyzed, and technical indexes of superhard abrasive material after treatment were summarized.
分析了各种方法的优缺点，并总结了处理后的技术指标。